Operation specification for packing belt production line

Packing belt production lines are widely used in enterprises, but some enterprises still have some irregular operations. In pursuit of work efficiency, some employees ignore the inspection of the packaging tape production line before the operation. This leads to a series of problems such as looseness, leakage, and damage. Therefore, in order to avoid these problems, how should enterprises standardize the operation process of the packaging belt production line?

Troubleshooting method of packing belt production line:

before the start. First make sure that the device and packing tape are inserted correctly. Check the power cord, then check whether the moving parts are lubricated, and then check whether the packaging tape production line is fixed. A strapping line operator needs to define the process. At the same time, it is necessary to have a basic understanding of the structure, working principle, operating procedures and adjustment methods of mechanical equipment. Before operation, we should turn on the power, preheat the packaging machine for a few minutes, adjust the length of the packaging machine, and of course listen to whether there is any noise in the packaging belt production line.

After operation, remember to cut off the power supply and turn off the switch to prevent leakage and cause electric shock. Modern people pay more and more attention to the packaging of food and gifts, and the demand and requirements for products such as packaging tapes are also increasing. Therefore, packaging belt production line manufacturers will attach great importance to the selection of packaging materials. It has some primary protection. It is the use of packaging materials to provide surface protection for the packaged products. In this way, a lightweight and highly protective surface can be produced on the product. It is very effective against shock, oil, moisture, and water, and can even achieve the purpose of anti-theft.

In addition to these operating procedures, these matters should also be paid attention to in the process of working on the strapping production line.

1. Adjust the temperature and gradually increase the temperature from the feeding stage to the homogenization stage. The mold temperature should be the same or slightly lower than the mechanical cylinder temperature of the packaging table.

2. When extruding the raw material of plasticized packaging tape, install the porous plate and filter first, and then simplify the machinery. The number and layers of nets are determined by the raw material and the working conditions of the belt.

3. The stock of the packing belt production line enters the water tank perpendicular to the water surface. When the blank is wider, appropriately increase the distance from the mold to the liquid surface, or increase the speed of the pulling tension roller. If the width of the blank is insufficient, the distance from the mold to the liquid surface should be reduced, or the speed of the tension roller should be appropriately reduced. If necessary, the speed of the screw can also be adjusted, and the extrusion size of the hot melt adhesive can be changed to adjust the width of the belt.

If you want to know more about PVC sheet equipment, foam board production line and wood plastic production line, you can follow us.